![]() ![]() If the TV brand is not successfully found by the remote control, the TV standby button will flash rapidly and the remote control will revert to normal operation. Should the TV model be changed and the remote control requires re-programming, repeat the above setup procedure with the new TV. If all the above mentioned buttons do not operate the TV set, a KEY FIX operation can be performed. The following buttons should now operate the TV set: TV Standby,ĪV source select, Volume Up, Volume Down, Mute. The TV control function is now programmed into the remote control. Press and hold the Text/SHIFT button and then at the same time press the STOP button to finish setting up the TV control mode. When the TV either turns off or brings up the MUTE symbol on screen, release the button. Point the remote control at the TV set and press and hold down the TV Standby button or the Mute button on the remote control.ħ. ![]() On entry of the 4th digit the TV standby button will flash then remain lit.Ħ. On each digit entry the TV standby button will flash. Now enter the 4 digit manufacturer code for your TV set. Press and hold both the 1 and the 3 buttons at the same time on the remote control for approximately 3 seconds until the TV standby button remains lit, then release both buttons.ĥ. (The set-top box does not need to be turned on to perform this programming feature).Ĥ. ![]() Look up the 4-digit manufacturer code supplied on the reverse side of this sheet and make a note of this code.ģ. Determine the manufacturer of your TV set.Ģ. The remote control will revert to normal operation and no TV brand code will be stored.ġ. In case of a mistake, the process can be exited at any point by pressing and holding the Text/SHIFT button and then at the same time pressing the STOP button. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |